The ABA film blower heats and melts plastic particles before blowing them into thin films. There are many kinds of film blowers, such as PE, POF, PVC, etc. The new ingredients blown out with the new particles are well-known, clean and stretched. The main reason for the poor production of recycled materials is that their performance may vary from batch to batch. In production, the ratio of recycled materials is determined by looking at the raw materials and understanding their hardness, density, melting index, blending with other recycled materials and blending with good materials.

The physical properties and transparency of the film are guaranteed to a certain extent by using recycled materials, which can be interpreted as poor longitudinal tension. It is recommended that you test at high pressure: linear = 2:3, and then do not add too much recycled material. You can also add a pack of metallocene properly inside. How much material an hour has, generally up to 120HP and below 20HP. If it is centralized cooling, it depends on the specific situation.

At present, our company has purchased Jinming machinery, KC-050FA water cooler, and Kedley brand for three centralized cooling applications. Particles are usually grey, and bags are usually made with pigments, which are unevenly colored, crisp, fragile and cheap.

Although they are recycled plastic bags, they are generally used as waste bags in the process of making bags and in the general sense. To enhance the cooling system of film blowers more efficiently, cooling is not enough. Use internal cooling or water coolers or other cooling equipment. Plastic quality A screw must first be able to produce products that meet the quality requirements.

The so-called conformity to quality requirements refers to that the products produced should conform to the following requirements: 1. Has all the required performance. Is there any pressure fluctuation in the resulting melt. Are the dyes and other fillers evenly dispersed? Unit consumption Unit consumption refers to the energy consumption per kilogram of plastic (rubber) extruded, which is generally expressed in terms of N. Among them, N is power (kW) and Q is output (kg/h). It is not easy to make a good screw, it must also be easy to process and manufacture, low cost.