ABA film blower is used for: blowing high and low pressure polyethylene film (LDPE, HDPE), products are widely used in composite film, packaging bags, agricultural covers, textiles, garment bags and other packaging, the main motor uses frequency conversion speed control, to increase the stability of the main machine, and to save electricity, the tractor rack uses lift type, which can make the film cooling effect better.

In order to get a plastic bag product with controllable quality in the processing of film blower, it is necessary to control each processing link in place. Generally, the processing process of the film blower consists of feeding heating, traction, and control of air pressure and edge closure. The size of the plastic bag is controlled by how much air is blown, and then it is stabilized by a membrane stabilizer.

ABA film blower is also called pseudo three-layer film blower. Its screw inlet and outlet are two extruder extrusion dies with three layers, and the resulting film is three layers. It is mainly used to produce filler A and A with new material B, which is the middle layer to put filler so that the quality of the film is good and the cost is low.

The traction device of the film blower uses a plastic sprayed steel herringbone, a new type of decelerated frequency conversion motor, cold pressing numbness points, a new type of adjustable edge inserter, automatic gas filling, and an LED photoelectric indicator. Film-forming features: The film is even, the insertion edges are neat, the pressing points are good-looking, beautiful, neat, thick and large.

At the entrance of the feeding section of the film blower, you want a lower temperature to prevent resin sticking from blocking the feeding port. In addition, the resin in the feeding section is continuously compressed and the air is poured out from the feeding port. According to the different construction of film blower equipment, the price of high-quality film blower, the feeding spout does not need electric heating, and the operation steps of the film blower, but through the barrel heat transfer, the feeding spout temperature is about 50-90 degrees. In this way, the temperature of the feeding section is determined.